Table of Contents
Advertisement
First-time Operation
2
2
3
1
Power Switch
Power Indicator
10
4
Open the display
Latch
1
Slide the latch located at the front.
2
Lift open the display.
CAUTION
Do not open the display wider than necessary (150° or more).
1
5
Connect your computer to a power outlet
CAUTION
Be sure the AC adaptor is connected until completing Step 9 on page 12.
When using the computer for the first time, do not connect any peripheral de-
vice except the battery pack and AC adaptor to the computer.
Handling the AC adaptor
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adaptor with your computer. Using an AC adaptor
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless running from the battery
pack alone.
6
Turn your computer on
Slide the power switch and hold it for approximately one second until the power indi-
cator turns on before releasing it.
CAUTION
Do not slide the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
7
Select the Operating System
Windows 2000 and Windows XP are preinstalled on this computer. After one of them
is selected with the following procedure, only that Operating System can be used.
At the screen for the agreement of the selection of the Operating System, select [Y].
1
2
With the number keys, select either Windows 2000 or Windows XP.
(The selection of the Operating System is only performed the first time the com-
puter is started up. A change cannot be made after the selection.)
At the confirmation message, select [Y]. The Operating System preparation will
3
start, during which the computer will restart.
CAUTION
Do not touch the keyboard. If you accidentally touch the keyboard and the
cancel confirmation menu is displayed, do not cancel.
When the screen indicating the completion of the Operating System preparation is
4
displayed, press any key.
The computer will restart.
Advertisement
Table of Contents
