Table of Contents
Advertisement
2.4 Configuration
To deploy the sensor, download the latestLoRa ToolAndroid App to setup LoRaWAN® credentials and other preferences :
Move the NFC antenna of the mobile (the exact position varies depending on the model of the smartphone) to the sensor antenna, in the area shown in the figure:
To use the NFC interface, the device must be powered through terminals L LINE and N LINE. The power status is visible on the red/green led.
Always validate your settings by reading the NFC data after the sensor has restarted.
Configuration can be done only via NFC. No USB port available.
2.5 System leds
LoRaWAN® not configured
Joining
Sending
Receiving
Steady state
Data error
Connection error
2.6 Firmware update
Download the latest firmwares available on the smartphone with LoRaTool app:
m2m Germany GmbH | Am Kappengraben 18-20 | 61273 Wehrheim | 06081 5873860
Slow flashing
Quick flashing
Quick flashing
Quick flashing
Fixed
Flashing 2 seconds
Flashing 1 second
Advertisement
Table of Contents
