Advertisement
Quick Links
Advertisement
Related Manuals for Trotec BE47
Summary of Contents for Trotec BE47
- Page 1 BE47 ORIGINAL INSTRUCTIONS MULTIMETER...
-
Page 2: Table Of Contents
• Insert the batteries into the battery compartment according to the correct polarity. • Remove discharged batteries from the device. Batteries contain materials hazardous to the environment. Dispose of the batteries according to the national regulations. multimeter BE47... - Page 3 To use the device for its intended use, only use accessories and Electric shock due to contact with live parts! When spare parts which have been approved by Trotec. using the measuring tips, make sure not to reach behind the protection against contact.
-
Page 4: Information About The Device
• Manual range selection Fuses • 2000 count LC display 10 A socket • Safety category CAT II 600 V / CAT III 300 V • AC and DC voltage measurement • Direct current measurement • Resistance measurement • Diode testing function • Acoustic continuity testing multimeter BE47... - Page 5 This measuring device is designed for V DC DC voltage: indoor use and complies with up to 200 mV DC overvoltage category CAT II 600 V / up to 2000 mV DC CAT III 300 V, pollution level 2. up to 20 V DC up to 200 V DC up to 600 V DC multimeter BE47...
-
Page 6: Transport And Storage
• + digits: Corresponds to the accuracy referring to the analogue to digital converter. Scope of delivery • 1 x Multimeter • 1 x Safety measuring lines with test probes • 1 x 9 V monobloc battery • 1 x Quick guide multimeter BE47... - Page 7 5. Insert the battery with the battery clip into the battery compartment. 6. Close the battery compartment and retighten the screw. 7. Place the device back into the protective cover. multimeter BE47...
- Page 8 ð The measured value will be indicated on the display. 4. Turn the rotary switch (2) to the position that is closest to the indicated value but does not fall below it. ð The measured value will be indicated on the display. Example: multimeter BE47...
- Page 9 3. Connect the measuring tips to the circuit to be tested. ð When the circuit is closed and the resistance is smaller than 30 Ω, an acoustic signal is emitted. ð When the circuit is open, OL is displayed. multimeter BE47...
-
Page 10: Maintenance And Repair
Apply the red test probe to the positive side of the battery. ð The measured value will be indicated on the display. Battery type Good Poor 1.5 V battery >1.35 V 1.22 to 1.35 V <1.22 V 9 V battery >8.2 V 7.2 to 8.2 V <7.2 V multimeter BE47... -
Page 11: Errors And Faults
You can also find out about other return options that apply for many EU countries on the website https://hub.trotec.com/?id=45090. Otherwise, please contact an official recycling centre for electronic and electrical equipment authorised for your country. - Page 12 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...