Advertisement
Quick Links
Advertisement
Related Manuals for Trotec BE49
Summary of Contents for Trotec BE49
- Page 1 BE49 OPERATING MANUAL DIGITAL MULTIMETER...
-
Page 2: Table Of Contents
• Protect the device from permanent direct sunlight. • Do not remove any safety signs, stickers or labels from the device. Keep all safety signs, stickers and labels in legible condition. • Do not open the device. digital multimeter BE49... - Page 3 Make sure that no water or other liquids can To use the device for its intended use, only use accessories and enter the housing. spare parts which have been approved by Trotec. Warning of electrical voltage Foreseeable misuse Work on the electrical components must only be...
-
Page 4: Safety
300, 600 or 1000 Volt. The • Diode testing function designation CAT III/1000 V for example means that the • Acoustic continuity testing measurement device may be used in low-voltage indoor • Hold function installation for voltages up to 1000 volts. digital multimeter BE49... - Page 5 200 mA Direct and alternating current: up to 10 A Designation LC display HOLD button Illumination button Rotary switch mA/V/Ω socket COM socket Red measuring tip Black measuring tip Fold-out stand Fuse compartment (below stand) Battery compartment 10 A socket MODE button RANGE button digital multimeter BE49...
- Page 6 28 °C and a relative humidity of less than 80 %. The accuracy specification consists of two values: • % value referring to the reading: Corresponds to the accuracy of the installation to be measured. • + digits: Corresponds to the accuracy referring to the analogue to digital converter. digital multimeter BE49...
-
Page 7: Transport And Storage
Inserting the batteries Insert the batteries before first use. Note Disconnect the measuring tips from the device before opening the battery compartment. Note Make sure that the surface of the device is dry and the device is switched off. digital multimeter BE49... - Page 8 • Do not switch any motors in the measuring circuit on or off during a measurement. Voltage peaks caused by a switch- on or switch-off can damage the measuring device. digital multimeter BE49...
- Page 9 1. For measuring the current, interrupt the circuit to be measuring ranges (see chapter Fuse replacement). checked and connect the measuring device in series with the consumer in this circuit. 2. Depending on the expected measuring current, turn the rotary switch to position , digital multimeter BE49...
- Page 10 • Value close to 0 mV: circuit is shorted falsified display. The resistance value displayed in case of short- circuited measuring tips will be put down in writing and later subtract from the measured value for the subsequent measurements. digital multimeter BE49...
-
Page 11: Maintenance And Repair
2. Loosen the screw of the fuse compartment and remove the Switching the device off fuse compartment cover. Info 3. Remove the defective fuse. After 15 minutes of inactivity the device switches off automatically. Switch the device off by turning the rotary switch to position OFF. digital multimeter BE49... -
Page 12: Errors And Faults
You can also find out about other return options that apply for many EU countries on the website https://hub.trotec.com/?id=45090. Otherwise, please contact an official recycling centre for electronic and electrical equipment authorised for your country. - Page 13 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...