Table of Contents
Advertisement
4 SETTINGS
4.1 General
Set values are lubrication system basic values, for example lubrication cycle and maximum
pressurization time.
All settings are password-protected.
4.2 Entering password
1.
Select the code for the setting to be changed on the display with
2.
Press SET –button.
3.
Display shows code PPP.
4.
In a moment the first character of the display starts to blink.
5.
Select with
6.
Move to the next character with
7.
When all three numbers of the password have been entered, press SET –button.
8.
When password has been entered correctly, code ACC is displayed and set values can be
changed during the next 10 minutes.
9.
If password has not been entered correctly, code Err is displayed and display returns to
normal mode.
Note
4.3 Entering settings
1.
Select the code for the setting to be changed on the display with
2.
Press SET –button.
3.
The first number of the value to be set is blinking on the display.
4.
Select the desired number with
5.
Move to the next number with
6.
The set value is saved in the memory with SET –button.
7.
Exit setting mode with
1 minute if the buttons have not been used.
4.3.1 Lubrication cycle counter
Lubrication cycle counter can be reset when needed.
1. Select the code Cou for lubrication cycle counter on the display with
2. Reset the counter with SET –button.
HUIF1BEN.doc
-button the first number of the password on the display.
-button.
Set value password is 103.
- button on the display.
-button.
-button. Display returns to normal mode automatically after
MULTILUBE
IF-103
7 (8)
-button.
-button.
-button.
16.06.2004 Rev. 1B
Advertisement
Table of Contents
