Phase Codes For Normal Mode And Alarm Mode; Normal Mode Displays - SAFEMATIC IF-103 User Interface Description

3.1.2 Phase codes for normal mode and alarm mode

In normal or alarm mode, the phase code corresponding to the program phase is shown on the
display.
Phase code
dC
Loc
OFF
AGr
ALP
AHP
AIn

3.1.3 Normal mode displays

Normal mode displays, which show lubrication program set values, can be browsed with
-button.
Display codes change in the following order when
Display code
Cou
C
P
PLo
PHi
Decimal points are used to separate thousands in lubrication cycle counter reading. Counter
max. reading is 49.9 = 49 999.
According to lubrication system basic settings pressure unit on the display is bar or psi. In psi –
reading decimal points are used to separate thousands. For example 1.02 = 1020 psi.
HUIF1BEN.doc
Description
Pressure discharge waiting time
(disCharge)
Interlocking switch is closed
(Locked)
System is turned off.
Lubricant barrel low level alarm
(Alarm, Grease)
Alarm, low pressure
(line pressure does not rise high enough during pressurization time)
(Alarm, Low Pressure)
Alarm, high pressure
(line pressure is not low enough when pressurization phase starts)
(Alarm, High Pressure)
Alarm from LG-ind doser operation indicators.
Code is used only if LG-ind doser operation indicators are in use.
(Alarm, Indicator)
Description
Lubrication cycle counter
(Cycle Counter)
Lubrication cycle set value [h.mm]
(Lubrication Cycle)
Maximum pressurization time set value [s]
(Lubrication, Pressurization time)
Low limit pressure set value [bar/psi]
(Pressure, Low limit)
Code is used only in pressure transmitter operation
High limit pressure set value [bar/psi]
(Pressure, High limit)
Code is used only in pressure transmitter operation
MULTILUBE
IF-103
-button is pressed.
4 (8)
16.06.2004 Rev. 1B