Reinstalling Software - Panasonic Toughbook CF-74CCB02BM Operating Instructions Manual

Reinstalling Software

When you reinstall the software, the hard disk data will be erased. Back up important data to other media or an exter-
nal hard disk before reinstallation.
Reinstalling software will return the computer to the default condition. The hard disk backup area and the backup data
( page 16) will be erased. (If you reinstall Windows in the first partition, the backup area and data will not be
erased.) Even if the data is stored in partitions on the hard disk, it may be erased or corrupted.
Preparation
Prepare the following items:
• The Product Recovery DVD-ROM (included)
• Panasonic CD/DVD drive (included)
Remove all peripherals (except for the CD/DVD drive).
Connect the AC adaptor and do not remove it until reinstallation is complete.
NOTE
Even if reinstallation is performed, the number of times of DVD's region code setting will not be reset.
1 Turn off the computer and insert the CD/DVD drive into the multimedia pocket
( Reference Manual "Multimedia Pocket").
2 Turn on the computer, and press
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
3 Write down all of the contents of the Setup Utility and press
At the confirmation message, select [Yes] and press Enter.
4 Select the [Boot] menu, then select [IDE MP] and press
the boot priority order.
5 Select the [Security] menu and set [CD/DVD Operation] to [Enable].
6 Set the Product Recovery DVD-ROM into the CD/DVD drive.
7 Press .
F10
At the confirmation message, select [Yes] and press Enter.
The computer will restart.
When the hard disk backup function has been enabled, the confirmation message appears to inform that the
backup function will be disabled, and the backup area and data will be erased. Press Y to proceed.
8 Press to execute [1. [Recovery]].
1
The License Agreement screen appears.
To cancel partway, press 0.
9 Press to select [1. Yes, I agree to the provisions above and wish to continue!].
1
10 Select the settings.
[2]: Enter the size of operating system partition and press Enter.
You cannot create the hard disk backup area if you select [2].
(The size of data partition will be determined by subtracting the operating system partition size from the
maximum size.)
[3]: Windows will be installed in the first partition.
(The size of the first partition must be 20 GB or more. If smaller, installation will not be possible.)
When the hard disk backup function has been enabled, the confirmation message appears to inform that the
backup function will be disabled, and the backup area and data will be erased. Press Y to proceed. If the
reboot message appears, press R to proceed.
At the confirmation message, press Y.
Reinstallation starts automatically. (It will take approximately 20 minutes.)
Do not interrupt reinstallation, for example by turning off the computer or pressing Ctrl + Alt + Del. Other-
wise reinstallation may become unavailable as Windows may not start up or the data may be corrupted.
11 Remove the Product Recovery DVD-ROM, and then press any key to turn off the com-
puter.
20
several times while [Panasonic] boot screen is dis-
F2
.
F9
until [IDE MP] is at the top of
F6