Advertisement
2-4-3 Before proceeding further, carefully check that cable you have just connected negative
terminal of inverter to the negative output power source.
2-4-4 Connect the cable from the positive terminal of the inverter to the postive terminal of
the power source. Make a secure connection.
2-4-5 Set the power switch to the ON position; you will hear the "bi-bi-bi" sound. At the same time,
the display is showed the word "ASIAN" for two times. After that, you will hear the
continuous sound from internal alarm. Then, the AC voltage shows on the display. It
means the device has done the operation.
2-4-6 Set the power switch to the OFF position; the device shut down completely.
2-4-7 Please use a power meter accurately measure the true output R.M.S. voltage of inverter.
We use a power meter such as IDRC CP-350 or ABM 2019 to measure our product.
klick to
klick to
www
www
u-s-v
Y O U R C O N N E C T I O N TO S A F E T Y
ACDC-DCDC
WARNING!
Make sure all the DC connections are tight (torque to 9-10
ft-lbs, 11.7-13Nm). Loose connections will overheat and could
result in a potential hazard.
CAUTION!
Reverse polarity connection will blow a fuse in inverter and
may permanently damage the inverter.
Damage caused by reversing polarity connection is not
covered by our warranty.
WARNING!
You may observe a spark when you make this connection since
current may flow to charge capacitors in the power inverter.
Do not make this connection in the presence of flammable
fumes. Explosion or fire may result.
klick to
www
Y O U R C O N N E C T I O N TO S A F E T Y
Y O U R C O N N E C T I O N TO S A F E T Y
SYSTEME
9
klick to
www
Y O U R C O N N E C T I O N TO S A F E T Y
CONTACT
YOUR CONNECTION TO SAFETY
klick to
www
Y O U R C O N N E C T I O N TO S A F E T Y
CALLBACK
Advertisement
