Page 1
Care & Cleaning Removing & Replacing the Oven Door • Do not lift the oven door by its handle. Doing so may damage the door. • Make sure the oven and the door are cool before you begin to remove the door. •...
1. Open the door fully. 2. Open the hinge locks fully on both sides. 3. Holding the door firmly on both dies, gently close it 4. Disengage the hinges and remove the door. Place about halfway. on a protected surface. To Replace the Oven Door https://producthelp.fisherpaykel.com/Manuals/Oven_Manuals/User_Guides/591008C_Wall_Oven/09_Care_and_Cleaning Updated: Sun, 09 Apr 2023 00:13:22 GMT...
Page 3
2. Align the hinge tongue with the hinge slots and 1. Hold the door firmly in an approximately halfway push the door until you feel the latches locate into open position. position on each side. 4. Close the oven door. 3.
Page 4
4. Lower the side racks carefully and gently place the retaining wire underneath the lock stud. Do not lower the side racks until the prongs are fully inserted into the slots so that you do not chip the enamel. Changing the Oven Light Bulbs The oven is illuminated by 12 volt / 20 watt halogen bulbs.
Oven bulb replacement is not covered by your warranty. Manual Cleaning Always Never • Before any manual cleaning or maintenance, first wait for • Never use a steam cleaner. the oven to cool down to a safe temperature to touch, then •...
Page 6
Always Never • Never use cleaning products with a chlorine or acidic base. • Never spray detergent or liquid onto the buttons on the control panel. Liquid may seep behind the button and damage the electronics. What? How? Important! Aluminum Framing of Oven Door Clean with a solution of mild detergent and hot water, then wipe dry.
Page 7
What? How? Important! water, then wipe dry. • Clean with a solution of mild Stainless detergent and hot water, • Always read the label to make sure that your stainless Steel Strip/ then wipe dry with a steel cleaner does not contain chloride compounds as Handle on microfibre cloth.