Table of Contents
Advertisement
Optional Power Bucket Teeth Installation
1. Park the power unit and power bucket on a level
surface and raise the power bucket high enough
to place blocks underneath.
2. Place 10 cm (4 inch) blocks or other supports un-
der the power bucket and lower the bucket until it
is resting on the blocks.
3. Engage the parking brake, shut off the engine,
and remove the ignition key.
4. Starting at one side of the power bucket, install
the sets of teeth (A) onto the front cutting edge of
the power bucket.
A
5.
Secure each set of teeth to the power bucket us-
ing two 3/8 x 1-1/4 inch carriage bolts inserted up
through the tooth and bucket. Secure with two
flange nuts and torque to 42 Nm (31 ft-lbs).
Removing the Power Bucket Teeth
1. Park the power unit and power bucket on a level
surface and raise the power bucket high enough
to place blocks underneath.
2. Place 10 cm (4 inch) blocks or other supports un-
der the power bucket and lower the bucket until it
is resting on the blocks.
3. Engage the parking brake, shut off the engine,
and remove the ignition key.
4. Remove the carriage bolts and flange nuts and
remove the teeth from the front edge of the
power bucket.
SERVICE
Optional Grapple Installation
1. Place the power bucket on a level surface.
2. With the help of an assistant, lift the grapple as-
sembly into place with the grapple frame brackets
(highlighted green) inside the right and left sides
of the bucket.
3. Install two 1/2 x 1-1/2 inch carriage bolts through
both the right and left grapple frame brackets and
the bucket sides and fasten with 1/2 inch nylon
locking flange nuts. Torque to 102 Nm (75 ft-lbs).
Service - 18
Advertisement
Table of Contents
