Table of Contents
Advertisement
WARNING
Always engage the parking brake, shut off the pow-
er unit engine, remove the ignition key, and ensure
that all moving parts have come to a complete stop
before inspecting the components, or attempting
any repair or adjustment.
ATTENTION
If any component requires replacement, use only
original Ventrac replacement parts.
Cleaning and General Maintenance
For best results, and to maintain the finish of the power
bucket, clean or wash the power bucket after each use
to remove dirt, mud, stones, mulch, or other debris.
Lubrication Locations
Lubrication is required at the following locations using
a lithium complex NLGI #2 grease.
Wipe the grease fittings clean before applying grease
to the grease fittings.
Refer to the maintenance schedule for service inter-
vals and the amount of grease.
Cylinder Ends & Bucket Pivot (Right & Left Sides)
Cylinder Ends & Bushings (Optional Grapple)
SERVICE
Storage
Preparing the Attachment for Storage
1. Clean the attachment to remove accumulated dirt,
mud, stones, mulch, or other debris.
2. Inspect for loose or missing hardware, damaged
components, or signs of wear. Repair or replace
any damaged or worn components.
3. Inspect the hydraulic hoses and fittings to ensure
tight, leak free connections.
4. Inspect the safety decals. Replace any decals that
are faded, illegible, or missing.
5. Apply grease to all grease points and wipe off any
excess grease.
6. Inspect the painted components for chips,
scratches, or rust. Clean and touch up the sur-
faces as needed.
Removing the Attachment from Storage
1. Clean the attachment to remove any accumulated
dust or debris.
2. Inspect the attachment as instructed in the Daily
Inspection section of this manual.
3. Test the attachment to ensure that all the compo-
nents are working properly.
Service - 17
Advertisement
Table of Contents
