Advertisement
Available languages
Available languages
Safety
Do not fill the petrol tank when the
motor is running (W). Do not smoke
when handling fuel (D).
Safety sign (W)
Access by the aft deck shall only be
used in unique situation due to the
stability. This sign warns for that.
The safety sign are placed on the
inner transom and the aft deck, if
some or all sign
would be remo-
ved will a check
pattern appear. In
these cases plea-
se contact Linder
Aluminiumboats.
Before setting off
Always make sure, prior to each boat trip,
that it is fitted with all necessary safety
equipment, such as an anchor, rope,
paddles, etc. Avoid standing up and be
sure to wear your life jacket (W).
If you fall overboard
Use the ladder at the stern of the boat
to climb back into the boat. NOTE! The
engine must be shut down (D).
28 (76)
Mooring
There are four bollards fitted to the
toe rail. There are 2 lock/mooring rings,
one in the stern and one in the rear
of the boat, all of which are approved
according to insurance category 3.
Mounting accessories
Any extra equipment or accessories
must be fitted to the boat using
acid-proof, stainless steel or aluminium
brackets and screws. Copper, brass or
incorrect brackets can cause galvanic
corrosion (C). Pressure-creosoted woo-
den floor boards can cause corrosive
damage to the boat (C). Do not use
any treatment to the wooden floor
board, which can affect the aluminium
negatively.
Transportation on trailer
Make sure that the center rollers on
the trailer support all the weight of
the boat on the keel. Adjust the side
supporters to eliminate all movement
of the boat. Do not forget to secure
the boat with appropriate straps. Make
sure the boat is empty during transpor-
tation (C). When trailing the boat with
drivable cover (not harbor cover) max
speed is 30 km/h.
After use in salt water, or if the boat
has been transported on salted roads,
we recommend that you immediately
rinse the boat and trailer in fresh water.
Environment
By filling up the fuel, avoid fuel waste.
A running engine releases exhaust
gases that can have a detrimental
effect on the environment. Reduce
speed and surges out of regard for
people´s security and comfort. Your
Linder is produced in recyclable materi-
al that you get paid for when the boat
has made the last trip. The material
can be recycling time after time! The
amount of aluminum is approx 90%
of the boat weight. You don't have to
disassemble the boat, just leave it to
the recycle company.
Regular service checks (C)
- Bilge pump
- Battery
- Electrical system (remove any oxidation
from switches and cable contacts)
- Steering system
- Tank and fuel pipe
- Bilge drain plug
Advertisement
