Open The Display - Panasonic Toughbook CF-18FDAZXVM Operating Instructions Manual

First-time Operation
DC-IN Jack
DC IN 16 V
Latch B
2
Latch A
Power Switch
Power Indicator
14
4
Connect your computer to a power outlet.
CAUTION
Be sure the AC adaptor is connected until completing the first-time use operation.
When using the computer for the first time, do not connect any peripheral de-
vice except the battery pack and AC adaptor to the computer.
Handling the AC adaptor
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adaptor with your computer. Using an AC adaptor
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
5

Open the display.

Pull up latch A and release latch B.
1
1
Lift open the display.
2
6
Turn your computer on.
Slide the power switch and hold it for approximately one second until the power indi-
cator turns on before releasing it.
CAUTION
Do not slide the power switch and hold it for more than four seconds; this will
cause the power to be turned off forcibly.
Do not slide the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
7
Setup Windows.
Moving the cursor ( ) or clicking buttons can be performed with the touch pad (
page 21).
CAUTION
Do not press any keys or touch the touch pad until [Windows XP Professional
Setup] is displayed.
At [Welcome to the Windows XP Setup Wizard], select [Next].
1
After reading the agreement, select [I accept this agreement] or [I don't accept this
2
agreement], then select [Next].
NOTE
If [I don't accept this agreement] is selected, the Windows setup will be aborted.
Select settings for your region, then select [Next].
3
Enter your name and organization and then select [Next].
4