Self-Timer - JVC GR-AX760 Instructions Manual

30
Downloaded from: https://www.usersmanualguide.com/
EN
Interval Timer Indicator
Recording
1min
Time Indicator 1 s
+
FAR NEAR
MENU
–
Tally lamp
START/STOP
INT. TIME
REC TIME
RM-V704U (provided)
Tel e Macro O FF
Gai n U p A G C
C ol or F il ter NO R .
Tape L eng th T45
Ti tl e
D ate/T im e
Su b Men u
Main Menu Screen
Ta lly ON
Inte rv a l Tim e r O FF
R e c Tim e OFF
J LIP ID NO . 0 7
Sub Menu Screen
RECORDING
Advanced Features (cont.)

Self-Timer

You can set the delay between pressing the Recording
Start/Stop button and the actual start of recording. If you
secure the camcorder, you (or whomever is operating the
camcorder) can enter the scene before recording starts.
ENGAGE RECORD-STANDBY
MODE
1
Make sure the lens cover is open, then set the Power
switch to "CAMERA".
SELECT MODE
2
Set the Shooting Mode selector to "PRESET".
ACCESS MAIN MENU SCREEN
3
Press MENU.
ACCESS SUB MENU SCREEN
4
Press – to move the highlight bar down to "Sub
Menu", then press NEAR. The Sub Menu screen
appears.
SET INTERVAL TIME
5
Press – to move the highlight bar down to "Interval
Timer", press NEAR, then press + or – to cycle
through the choices. Stop when the desired time
appears. Choose from "15S", "30S", "1min",
"5min", or select to turn the function "OFF". Then
press FAR twice to return to the Main Menu screen.
CLOSE MAIN MENU
6
Press MENU.
START DELAYED RECORDING
7
Press the Recording Start/Stop button. If you set the
tally lamp to "ON" (
and the blinking frequency increases about 5
seconds before recording is to start. Once recording
begins, the lamp stops blinking but stays lit.
To Release Self-Timer . . .
.... while the tally lamp is blinking, press the Recording
Start/Stop button to stop the blinking, then set
"Interval Timer" to "OFF" or press INT. TIME on the
remote control until " " disappears.
.... while the tally lamp is lit but not blinking, press set
"Interval Timer" to "OFF" or press INT. TIME on the
remote control until " " disappears.
NOTE:
Instead of performing steps 2 – 6, you can set the interval
time by pressing INT. TIME on the remote control.
pg. 27), it begins blinking,