StetSom Venom V 1000.5 User Manual

StetSom Venom V 1000.5 User Manual

Advertisement

SPECIFICATIONS

MODEL:
Channels:
Power @ 13.8V 2 Ohms:
Power @ 13.8V 4 Ohms:
2x200 BRIDGE Watts RMS
Minimum Output Impedance
Input Impedance:
Minimum Sensitivity:
Total Harmonic Distortion:
Signal to Noise:
Crossover HIGH PASS:
Crossover LOW PASS:
Freq. Response (-3dB) @ 2 Ohms:
Power Tension:
Consumption Signal Musical:
Consumption Signal BASS:
Dimensions (A x L x C):
Weight:

HOW TO ACT IN CASE OF PROBLEMS

NOT TURN ON:
- The cables are not correctly connected (terminals BAT, GND and REM). Make sure that all connections
has mechanical and electrical contact.
- Fuses/circuit breakers (external) are defective or burned. Take care about the correct value of the
new fuse!
NO SOUND:
- The cables of speakers or plugs RCA are not connected correctly.
- Check if the LEVEL control is not in the minimum.
NO SOUND / RED LED (PROTECTION) ILLUMINATED:
- Speakers or cables (damaged), so, check speakers, cables and connections.
- Check the battery charge.
BAD SOUND QUALITY (DISTORTION):
- The speakers are overloaded, so, decrease the level and redo the gain adjustment (see iten 2/general
description).
WEAK BASS:
- Cables of speakers (+) and (-) are changed, speakers out of phase (see iten 5/general description).
Phone: (786) 2651960 - www.stetsom.com - export@stetsom.com
All manuals and user guides at all-guides.com
V 1000.5 - STEREO
V 1000.5 - MONO
4
1
4x100 Watts RMS
1x625 Watts RMS
1x450 Watts RMS
2 Ohms
2 Ohms
15K Ohms
0,2V
< 0,9 % THD
> 90 dB
70Hz to 700Hz
-
50Hz to 20KHz
20 Hz to 22 KHz
20Hz to 20KHz
9 to 15V
1,5 to 45A
1,5 to 90A
40x240x365 mm
3,0 Kg
VENOM LINE
VENOM LINE
USER'S GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Venom V 1000.5 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for StetSom Venom V 1000.5

  • Page 1 - The speakers are overloaded, so, decrease the level and redo the gain adjustment (see iten 2/general description). WEAK BASS: - Cables of speakers (+) and (-) are changed, speakers out of phase (see iten 5/general description). Phone: (786) 2651960 - www.stetsom.com - export@stetsom.com...
  • Page 2 All manuals and user guides at all-guides.com OVERVIEW INSTALLATION OUTPUT OF SPEAKERS The amplifier can work with 3 or 5 independent channels the speaker impedance varies from 2 to 4 AUDIO INPUT AND CONTROLS ohms according to the chosen mode. Be aware of the correct polarity when installing the speakers. The speaker power must be at least the same as the power delivered by amplifier channel.

Table of Contents