Tests: Service Tests
2.2.14 Bluetooth
During this test, the distance between the phone and
the target Bluetooth device must be 1.5 to 5 meters!
Make sure the target Bluetooth device is enabled and
visible always.
The Bluetooth test will be done in following sequences:
Step 1: Enable Bluetooth; wait 4-5 seconds, shows OK,
There is a permission request, select 'Allow'.
Step 2: Searching
Step 3: Show the Device Found list
Step 4: Select the Target Bluetooth Device,
Step 5: Check the Pairing PIN code on both Target
Bluetooth Device and phone, press Pair on both,
when succeeded, it shows "Test Complete".
Press the Back key to return to the Service Test Menu.
2.2.15 WLAN
Make sure there's a WLAN network before performing
this test.
The WLAN test will be done in following sequences:
Step 1: Enable WLAN, start searching
Step 3: Access points Found list
Step 4: Select the Target WLAN network, and type the
password to get connected
Step 5: Enter a web address (e.g. Google.com)
Step 6: When connection succeeded, it shows "Test
Complete".
Press the Back key to return to the Service Test Menu.
1277-1359 Rev 2
© Sony Mobile Communications AB – Company Internal
Test Instructions (mech)
13(25)