Ninja INTELLI-SENSE CT682SP Series Owner's Manual page 4

IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE USE • FOR HOUSEHOLD USE ONLY
WARNING
33 DO NOT perform grinding operations
with the Single-Serve Blending Cup
and Pro Extractor Blades® Assembly,
the pitcher and Stacked Blade Assembly,
or the processor bowl and Chopping
Blade Assembly.
34 NEVER operate the appliance without
lids and caps in place. DO NOT attempt
to defeat the interlock mechanism.
Ensure the container and lid are
properly installed before operation.
35 Before operation, ensure all utensils are
removed from containers. Failure to
remove utensils can cause containers to
shatter and potentially result in personal
injury and property damage.
36 Keep hands and utensils out of
containers while chopping to reduce the
risk of severe personal injury or damage
to the blender/food chopper. A scraper
may be used ONLY when the blender
or processor is not running. When using
the processor, always use food pusher
to add food. NEVER add food by hand.
37 If you find unmixed ingredients sticking to
the sides of the cup, stop the appliance,
remove the blade assembly, and use a
scraper to dislodge ingredients.
38 DO NOT open the pitcher's pour spout
cap while blender is operating.
39 If you find unmixed ingredients sticking
to the sides of the pitcher, stop the
appliance, remove the lid, and use a
spatula to dislodge ingredients. NEVER
insert your hands into the pitcher, as
you may contact one of the blades and
experience a laceration.
40 DO NOT attempt to remove the
container or lid from the motor base
while the blade assembly is still
spinning. Allow the appliance to come
to a complete stop before removing lids
and containers.
41 If the appliance overheats, a thermal
switch will activate and temporarily disable
the motor. To reset, unplug the appliance
and allow it to cool for approximately
30 minutes before using again.
6 ninjakitchen.com
42 DO NOT expose the containers and
accessories to extreme temperature
changes. They may experience damage.
43 Upon completion of processing,
ensure the blade assembly is removed
BEFORE emptying container's contents.
Remove the blade assembly by carefully
grasping the top of the shaft and lifting
it from the container. Failure to remove
the blade assembly before emptying the
container results in a risk of laceration.
44 If using the pitcher's pour spout, hold
the cover in place on the container or
ensure lid lock is engaged when pouring
to avoid risk of injury.
45 Remove the Pro Extractor Blades
Assembly from the Single-Serve Cup
upon completion of blending. DO NOT
store ingredients before or after
blending them in the cup with the
blade assembly attached. Some foods
may contain active ingredients or
release gases that will expand if left in a
sealed container, resulting in excessive
pressure buildup that can pose a risk
of injury. For ingredient storage in the
cup, use only Spout Lid to cover.
46 The maximum wattage rating for this
appliance is based on the configuration
of the Pro Extractor Blades Assembly and
Single-Serve Cup. Other configurations
may draw less power or current.
47 DO NOT submerge the motor base or
control panel in water or other liquids.
DO NOT spray motor base or control
panel with any liquid.
48 DO NOT attempt to sharpen blades.
49 Turn off the appliance and unplug the
motor base before cleaning.
50 To reduce the risk of injury from
damage to the food processing bowl or
separation of the lid, DO NOT load the
bowl with ice cubes for crushing.
SAVE THESE INSTRUCTIONS
ninjakitchen.com 7