8
UNPACKING AND UNBLOCKING THE MACHINE
When selecting the location in which to install the machine, follow the advice given below
area:
▼
The room must be provided with a water supply, drainage system and mains power
supply (remember that the cables and hoses on the back of the washing machine
must not be squashed).
▼
The washing machine must be placed on a hard fl at surface.
▼
It is advisable to avoid installing the washing machine in a room where the tem-
perature may fall below 3 °C.
▼
Position the washing machine near to its place of installation and remove the external
packaging (fi g.2).
▼
Lift the washing machine and remove the polystyrene base and the plastic
spacer (fi g. 3).
▼
Loosen the 2 screws (fi g. 4) or the 4 screws (fi g. 5) (according
to the model) that secure the moving pieces and remove them
together with the plastic bushes (fi g. 2). Close the holes with the
plastic plugs supplied.
▼
Pick up the screws and bushes and keep them for future transpor-
tation
▼
Incline the washing machine and extract the two internal polystyrene corner pie-
ces (if present) by pulling the two cardboard strips, fi rst E and then F (fi g.6).
GB
INSTALLING THE MACHINE
2
3
V
4
V
5
E
F
6
SM2138