Advertisement
Install the Device/ 设备安装
D Embedded-Mount / 嵌入式安装
1
Remove the decorative box on the embedded bracket.
拧松嵌入式支架上的装饰盒，拆除装饰盒。
Fix the camera and the embedded bracket on the ceiling. Fasten the
4
screws and Undercut flat screw on the embedded bracket. Then, fix the
embedded bracket on the ceiling. After the embedded bracket is fixed,
adjust the shooting angle of the camera.
将摄像机及嵌入式支架安装到天花板上，拧紧嵌入式支架上的螺丝和倒扣，将
嵌入式支架固定到天花板上。固定好后，调整摄像机的监控角度。
2
Use a Phillips screwdriver to remove the transparent cover and place the camera
in the embedded bracket. Align the installation screws of the camera with the
installation holes on the embedded bracket. Lead the M4 screws through the
screw holes and fasten the screws.
使用十字螺丝刀将透明罩卸下 , 将摄像机装入嵌入式支架中，将摄像机的安装螺孔对准嵌
入式支架安装盘上的对应安装槽，将支架自带的 M4 螺钉穿过螺孔，拧紧螺钉。
Align the transparent cover with the screw holes on the camera base
5
and close the transparent cover. Use a Phillips screwdriver (a torque of
5-7 kgf.cm) to tighten the screws. And then tore off the protective film.
将 透 明 罩 和 摄 像 机 底 座 的 螺 孔 位 置 对 齐， 合 上 透 明 罩 并 使 用 十 字 螺 丝 刀
（5~7Kgf.cm 的扭矩）拧紧螺钉。然后撕掉透明罩保护膜。
3
According to the size of the stickers. Drill a hole with a
diameter of 178 mm on the ceiling.
按 照 贴 纸 尺 寸， 在 天 花 板 上 打 孔， 直 径 为 178mm， 厚 度
3mm~35mm。
Align the decorative box with the screw holes on the embedded
6
bracket and fasten the screws. Then, the installation is complete.
将装饰盒和嵌入式支架上的螺孔位置对齐，拧紧螺丝固定，安装完成。
Advertisement
