Advertisement
Install the Device/ 设备安装
C Ceiling-Mount/ 吊装
Place the ceiling-mount bracket to the required installation location,
1
use a marker to mark the screw installation positions. Obtain a drill
bit with a 8 mm diameter and drill four 50 mm holes in the specified
positions marked by the stickers.
将吊装支架放置于安装位置，使用记号笔绘制螺钉安装位置。依照贴纸上的标
注，选择直径为 8mm 的钻头，钻取深约 50mm 的导孔。
Use a
Phillips screwdriver
to remove the
transparent
4
使用十字螺丝刀将透明罩卸下。
Use a hammer to carefully drive the white plastic expansion tubes into
2
the
holes.
使用羊角锤将白色塑料膨胀管打入钻好的孔内。
cover.
Align the tapped holes of the camera with installation slots on the
5
ceiling-mount bracket plate, thread the M4 screws through the holes,
and tighten the screws.
将摄像机的安装螺孔对准吊装支架安装盘上的对应安装槽，将 M4 螺钉穿过
螺孔，拧紧螺钉。
Thread the cables through the ceiling-mount bracket. Put the four
3
plastic expansion tubes
the ceiling-mount bracket, and tighten the screw.
将需要与摄像机尾线对接的线缆穿过吊装支架。将吊装支架底座上的 4 个螺
孔套在相应的膨胀管上，拧紧螺钉。
Align the tapped holes on the edge of the ceiling-mount bracket
6
plate with the tapped holes on the installation bowl, and use a Phillips
screwdriver to tighten the screws.
将安装盘边上的螺孔对准安装碗的四个螺孔，使用十字螺丝刀拧紧螺钉。
NOTE/ 说明
F o r d e t a i l s a b o u t s u b s e q u e n t i n s t a l l a t i o n
operations, see steps 4 to 5 in B Surface-Mount.
后续安装的具体过程请参见"B 吸顶安装"中的步骤
4-5。
4
through the four screw holes at the bottom of
Advertisement
