Before Each Use; Operating Instructions - Roughneck 58079 Owner's Manual

PUMP OPERATION
•
If the pump has already been primed and the compressed air feed is connected to the appropriate
work pressure level (70-115psi), the pump will start automatically when the nozzle or gun situated
at the end of the grease delivery circuit is opened.
•
To stop the pump, simply close the nozzle or disconnect the air inlet line.

Wear ANSI Z87.1 compliant goggles and other protective gear while operating.

Inspect before each use; check that all connections are tight and secure.

Never use if parts are damaged or broken; replace damaged or broken parts before operating.

DO NOT try to mend it with tape or any other device. A repaired hose cannot safely contain the high
pressure fluid.

The compressed air must be filtered to avoid dust and moisture into pump.

Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the
Technical Data section of all equipment manuals. Read the fluid and solvent manufacturer's
warnings.

Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents, or
fluids containing such solvents in pressurized aluminum equipment. Such use could result in a
chemical reaction, with the possibility of explosion.

Disconnect air hose and relieve air pressure before servicing.

Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces.

Wear ANSI Z87.1 compliant goggles and other protective gear while operating.

Wear an adiabatic glove when operating pump.

Do not exceed the maximum working air pressure of 115 PSI.

Never point the dispenser at people or animals.

Do not use the pump near open flames. Do not smoke during this operation.

When not in use, disconnect the air supply air to the pump.

The compressed air must be filtered to avoid dust and moisture into pump.

Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the
Technical Data section of all equipment manuals. Read the fluid and solvent manufacturer's
warnings.

Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents, or
fluids containing such solvents in pressurized aluminum equipment. Such use could result in a
Page 14 of 25

Before Each Use

⚠WARNING

Operating Instructions

⚠WARNING