Table of Contents
Advertisement
Available languages
Available languages
OPERATING INSTRUCTIONS
This heater features a tip-over switch on the bottom so be sure to place the unit on a
flat, even surface.
SWITCHING ON AND SETTING TEMPERATURE
1.
Insert the plug into the power socket.
2.
Turn the power dial to the desired level:
a.
LOW – Low heat (1200W)
b.
HIGH – High heat (2000W)
c.
LOW SWING – Low heat oscillation (1200W)
d.
HIGH SWING – High heat oscillation (2000W)
3.
Turn the temperature control dial until you hear a click – this will turn the unit on.
Continue turning the dial to your desired temperature. The temperature control
dial acts as a thermostat. Once the room has reached the desired temperature
the unit will switch off.
SWITCHING OFF
1.
Turn the power dial to the OFF position.
2.
Turn the temperature control dial anticlockwise to the lowest setting.
3.
Remove the power plug, store the heater after the unit has cooled down.
CLEANING & STORAGE
WARNING: Always turn the heater OFF, unplug the power cord from the electrical outlet
and allow the appliance to completely cool down before handling or cleaning it.
CAUTION: Do not allow water or other liquids to run into the interior of the heater, as
this could create a fire and/or electrical hazard.
CAUTION: Do not use any abrasive cleaners or solvents, as heater damage will occur.
-
Clean the exterior surface of the heater by wiping it with a soft, damp cloth. Dry
the heater with a soft clean cloth.
-
Clean the air inlet and outlet grills regularly with a vacuum cleaner, using the brush
attachment to avoid any dust build-up.
-
To store your product out of season, we recommend using the original or similar
size box.
English | 4
Advertisement
Table of Contents
