Electrical Connection; Connecting The Supply Cable To The Mains - Daniela DAN90ASO User Manual

Table of Contents

Advertisement

ELECTRICAL CONNECTION

Those ovens equipped with a three-pole power supply cable are designed to operate with an
alternating current. The wire for earthling the appliance is yellow-green in colour.

CONNECTING THE SUPPLY CABLE TO THE MAINS

Install a standardized plug corresponding to the load indicated on the data plate. When
connecting the cable directly to the mains, install an omni polar circuit breaker with a minimum
contact opening of 3 mm between the appliance and the mains. The omni polar circuit breaker
should be sized according to the load and should comply with current regulations (the earth wire
should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than
50ºC with respect to the room temperature, anywhere along its length, or protected by insulation
sleeping having an appropriate rating.
Before making the connection, check that:
The electrical safety of this appliance can only be guaranteed if the oven is correctly and
e ciently earthed, in compliance with regulations on electrical safety.
Always ensure that the earthling is e cient; if you have any doubts call in a qualified
technician to check the system.
The manufacturer declines all responsibility for damage resulting from a system which
has not been earthed.
Before plugging the appliance into the mains, check that the specifications indicated on
the date plate (on the appliance and /or packaging) correspond to those of the electrical
mains system of your home.
Check that the electrical capacity of the system and sockets will support the maximum
power of the appliance, as indicated on the data plate. If you have any doubts, call
in a qualified technician.
If the socket and appliance plug are not compatible, have the socket replaced with a
suitable model by a qualified technician.
The latter in particular, will also have to ensure that the cross section of the socket
cables, are suitable for the power absorbed by the appliance.
The use of adapters, multiple sockets and /or extensions, is not recommended. If their
use cannot be avoided, remember to use only single or multiple adapters and
extensions which comply with current safety regulations. In these cases, never exceed the
maximum current capacity indicated on the single adapter or extension and the maximum
power indicated on the multiple adapter.
D A N I E L A
P
I
02 9604 1226
P | 0 2 9 6 0 4 1 2 2 6 E | s a l e s @ d a n i e l a a p p l i a n c e s . c o m . a u | W d a n i e l a a p p l i a n c e s . c o m . a u
E
I
sales@danielaappliances.com.au
Pg 8
W
|
danielaappliances.com.au
PA G E 9
D A N 9 0 A S O

Advertisement

Table of Contents
loading

Table of Contents