Pre Installation Considerations; Select Location - AGA marvel M18SZ Installation, Operation And Maintenance Instructions

Electrical receptacle location
for 18" wide models (M18SZ)-
20"(50.8cm) minimum
24" wide models
84 ⁄ " to 84 ⁄ "
1 7
4 8
(214cm) to (215.6cm)
Figure 4
Model
M18SZ
M24SZ
M24DZ
MPRO24DZ

Select Location

Locate the wine cellar in the coolest part of the room, out of
direct sunlight and away from heating ducts or registers.
Do not place the wine cellar next to heat-producing appli-
ances such as a range, oven or dishwasher. If this is not
possible, a section of cabinetry or an added layer of insula-
tion between the two (2) appliances will help the wine cellar
operate more efficiently.
Do NOT install the wine cellar where the temperature will
drop below 65 degrees F (18 degrees C) or rise above 90
degrees F (32 degrees C). The compressor will NOT be
able to maintain proper temperatures.

PRE INSTALLATION CONSIDERATIONS

22" (55.9cm)
78 ⁄ " (199.4cm)
1
2
Minimum, typical
"Cut out
width"
24" (61cm)
Cut-Out Width
17 ⁄ " (44.4cm)
1
2
23 ⁄ " (59.7cm)
1
2
23 ⁄ " (59.7cm)
1
2
23 ⁄ " (59.7cm)
1
2
Table A
NOTE
Floor under product MUST be at or above the same level
of the surrounding finished floor, for ease of installation and
removal of unit
When planning your rough in opening a 3" removable filler
panel is recommended above the grille. To remove the
power module from the cabinet the front has to be tilted up
as shown in Figure 5 when removed for service.
-3" (7.6cm) removable filler
recommended
84 ⁄ "
5
8
(214.9cm)
Maximum
9
Figure 5