Installing Your Wine Cellar; Outdoor Installation; Cabinet Clearances; Leveling Legs - AGA marvel 3SWCE Installation And Maintenance Instructions Manual

Select Location
The proper location will ensure peak performance of your ap-
pliance. We recommend a location where the unit will be out
of direct sunlight and away from heat sources. To ensure your
product performs to specifications the recommended installation
location temperature range is from 55 to 100°F (13 to 38°C).

Outdoor Installation

Only the 6OSWCE model is suitable for outdoor installations.
Building codes may require a ground fault circuit interrupter
electrical receptacle to supply electrical power to the refrigerator
for outdoor applications, (see "Electrical Connection" section).
Do not install in an environment where the unit will be exposed
to direct sun exposure as this may result in unsatisfactory perfor-
mance.
Cabinet Clearance
Ventilation is required from the bottom front section of the unit.
Keep this area open and clear of any obstructions. Adjacent
cabinets and counter top can be installed around the unit as long
as the grille and door access remain unobstructed.
Front Grille
Do not obstruct the front grille. The openings within the front
grille allow air to flow through the condenser heat exchanger.
Restrictions to this air flow will result in increased energy usage
and loss of cooling capacity. For this reason it is important this
area to not be obstructed and the grille openings kept clean.
AGA MARVEL does not recommend the use of custom made
grilles as air flow may be restricted because of inadequate open-
ings. (See Figure 2).
Figure 2

INSTALLING YOUR WINE CELLAR

Front Grille, keep
this area open.

Leveling Legs

Leveling Legs
Adjustable legs at the front and rear corners of the unit should
be set so the unit is firmly positioned on the floor and level from
side to side and front to back. The overall height of your Marvel
refrigerator may be adjusted from 33-3/4" (85.7cm) with the lev-
eling legs turned in, and up to 34-3/4" (88.3cm) with the leveling
legs extended. The 30" wide product (8SWCE), have a center leg
at the rear of the cabinet that must also be used to stabilize the
cabinet. (See Figure 3).
To adjust the leveling legs, place the refrigerator on a solid
surface and protect the floor beneath the legs to avoid scratch-
ing the floor. With the assistance of another person, lean the
refrigerator back to access the front leveling legs. Raise or lower
the legs to the required dimension by turning the legs. Repeat
this process for the rear by tilting the refrigerator forward using
caution to prevent the door from opening. On a level surface
check the refrigerator for levelness and adjust accordingly.
The front grille (toe kick) screws may be loosened and adjusted
to the desired height. When adjustment is complete tighten the
two toe kick screws. (See Figure 4).
Figure 3
Rear of unit
with access
cover removed
Rear leveling legs
at outside corners
4
Center rear leveling leg
on 30" wide units only