Error Information Page - Panasonic PT-D5500U Operating Instructions Manual

Using Web Browser Control

Error information page

When
• Depending on the nature of the error, the projector may be placed in the standby mode for its own
Note
protection.
When [FAILED] has appeared for an item
Parameter
MAIN CPU BUS
FAN
OPTICS MODULE
TEMPERATURE
INPUT AIR
TEMPERATURE
LAMP REMAIN TIME
LAMP STATUS
OPTICS MODULE
TEMP. SENSOR
INPUT AIR TEMP.
SENSOR
BATTERY
COLOR WHEEL
If requesting service, ask your nearest Authorized Service Centre.
48
is displayed on the status information screen, click it to display the error details.
Trouble has occurred in the microcomputer circuitry. Consult your dealer.
Trouble has occurred in the fan or its drive circuit.
Consult your dealer.
The temperature inside the projector is high.
The input air temperature is too high. It may be that the projector is being used
where the ambient temperature is high such as near a heating appliance.
The lamp runtime has exceeded the prescribed cumulative time, and it is now time
to replace the lamp.
The lamp has failed to light.
Trouble has occurred in the temperature detection sensor inside the projector.
Consult your dealer.
Trouble has occurred in the sensor used to detect the input air temperature.
Consult your dealer.
The backup battery has been run out.
Consult your dealer.
Trouble has occurred in the color wheel or the color wheel drive circuit.
Consult your dealer.
OK: Normal operation
FAILED: Occurrence of trouble
Description