Lamp Unit Replacement Steps - Panasonic PT-D4000E Operating Instructions Manual

Lamp unit replacement steps

Turn the power off by following the steps on page 22, remove the power plug and
confirm that the surroundings of the lamp unit have cooled off.
Check that the fan has stopped running.
Lamp unit cover
Lamp unit 2
Lamp unit
Fixing screws
Handle
Caution
The lamp unit will be hot after it has
been used.
You might get burned if you touch it while it is
still hot.
Lamp unit 1
Have a Phillips screwdriver ready ahead of time.
Remove the screw securing the lamp unit
cover, and then slide the lamp unit cover
a little toward the left, and remove it.
Remove the two screws securing the
fan unit.
• The lamp units are constructed so that
Note
the screws in step
through completely.
Open the fan unit as shown in the
figure.
Remove the screws securing the lamp
units (two for each unit), take hold of
the handles, and remove the lamp units.
Install the new lamp unit.
Use a Phillips screwdriver to securely
tighten the 2 lamp unit fixing screws
(two for each unit).
Secure the two screws for securing the
fan unit tightly.
Slide the cover a little toward the right,
and secure it using the screw for
securing the lamp unit cover tightly.
• Firmly install the lamp unit and lamp
Attention
unit cover. If not installed firmly, a
protection circuit will function and the
power will not be turned on.
do not fall
53