Table of Contents
Advertisement
Setting the CLOCK
Press CLOCK.
1 1
(If the clock requires setting, press and hold
CLOCK for more than 2 seconds.)
- The hours begin to flash.
Select a 12 hour cycle or 24 hour cycle by
2 2
pressing TUNING (
(12HR)
Press SET to confirm the selected hour cycle.
3 3
Sleep Function
When the sleep timer is used, the power is automatically turned off after the specified time has elapsed.
To specify the time delay before the power is
1 1
turned off, press SLEEP.
In the display window you can see
for about 5 seconds. This means that the system
turns off automatically after 90 minutes.
Each time the button is pressed the time interval
before it turns off is reduced by 10 minutes. i.e.
80...70... etc.
Select the desired time to turn off.
To check the remaining time until the power is
2 2
turned off.
While the sleep function is active press SLEEP
briefly. The time remaining until it turns off is
displayed for about 5 seconds.
Auxiliary Function
Connect an auxiliary device i.e. TV or VCR, via the rear mounted AUX phone sockets.
1 1
Press AUX.
2 2
ote
You can also record from the auxiliary input source, see Recording Section.
8
) on the front panel.
or
(24HR)
Use TUNING (
) buttons to set the
4 4
correct hours on the front panel.
Press SET.
5 5
Use TUNING (
) buttons to set the
6 6
correct minutes on the front panel.
Press SET and the correct time is shown on
7 7
the display.
Press CLOCK at any time to display the time
8 8
for about 3 seconds.
ote
The unit can also set the clock function in power off
state.
ote
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel the sleep timer mode
If you wish to stop the function, press the SLEEP button
repeatedly until "SLEEP 10" appears, and then press
SLEEP once again while "SLEEP 10" is displayed.
Advertisement
Table of Contents
