yuna EBK4/2B Instruction Manual page 40

zones which are still hot!
1. Disconnect the appliance from the
mains (fuse-box).
2. Hold the scraper in a 30
scrape off the contamination to a
cold area.
3. Clean the contaminated area with a
dish towel/kitchen paper.
4. Proceed as described in steps 2-4 in
the previous section.
1. Disconnect the appliance from the
mains (fuse-box).
2. Take away the contamination.
3. Wipe the sensors with a damp
sponge or cloth.
4. Dry the sensors with kitchen paper.
5. Connect the appliance to the mains.
Do not use any abrasive detergents! Do not use any organic detergents!
DANGER!
CAUSES
Break in the power supply.
The sensors are locked.
Liquid on the sensors.
2 Detergents such as vinegar, citric acid etc.
0 -angle and
Contamination of the control panel.
Do not use essential oils!
Replacing of the power cord
The power cord must be replaced by a qualified and
authorized professional only.
9. TROUBLE SHOOTING
The appliance cannot be switched on.
The sensors do not respond.
The sensors are difficult to operate.
difficult to remove and may damage
the glass ceramic permanently.
Be very careful when using the
scraper so that you do not cut
yourself (especially, when you have
removed the safety cover).
The appliance
automatically turn off. The sensors may
not work properly when they are wet.
Dry the control panel carefully before
you put it into operation again.
ERROR
Check
connected to the mains. Check the
household fuse box. Is there a power
failure at your place of residence?
Unlock the sensors.
Dry the sensors.
40
may beep
MEASURES
that the appliance
and
2
is