Getting Started; Charging The Battery; Powering On - VOLTCRAFT 2525736 Operating Instructions Manual

10 Getting started

10.1 Charging the battery

Before you use the thermal imager fully charge the battery.
Important:
Make sure the thermal imager is near room temperature before charging. Do
not charge the battery in particularly hot or cold conditions.
1. Connect the supplied USB charging cable to a USB power supply and the
USB-C™ port on the thermal imager.
The charging indicator shows on the display.
Æ
2. Charge the battery until the charging indicator displays
3. Disconnect the USB charging cable.

10.2 Powering on

1. To turn the thermal imager on, press and hold the power button
2 seconds and then release the button.
The screen switches on and starts calibrating for several seconds.
Æ
Note:
You cannot power on the thermal imager if you are charging it.
Note:
After powering on, the thermal image needs sufficient warm-up time to ensure
the most accurate temperature measurements and best image quality.
.
for approx.
57