Table of Contents
Advertisement
Instruments and indicators
your Yamaha dealer on how to correctly set
the selector switch. NOTICE: Running out of
fuel can damage the engine.
EMU36072
Trip meter / Clock / Voltmeter
The display shows either the trip meter, the
clock, or the voltmeter.
To change the display, press the "
(mode) button repeatedly until the indicator
on the face of the gauge points to "
meter), "
" (clock), or "
EMU26692
Trip meter
This gauge displays the distance the boat has
traveled since the gauge was last reset.
The trip distance is shown in kilometers or
miles depending upon the unit of measure-
ment selected for the speedometer.
To reset the trip meter to zero, press the "
(set) and "
" (mode) buttons at the same
time.
The trip distance is kept in memory by battery
power. The stored data will be lost if the bat-
tery is disconnected.
SPEED
TRIP
set
EMU26702
Clock
To set the clock:
1.
Be sure the gauge is in the "
mode.
2.
Press the "
" (set) button; the hour dis-
play will begin blinking.
3.
Press the "
desired hour is displayed.
35
[ECM01771]
" (voltmeter).
YAMAHA
km/h
knot
mph
km
mile
TIME
BATT
mode
ZMU07003
" (time)
" (mode) button until the
4.
Press the "
minute display will begin blinking.
5.
Press the "
desired minute is displayed.
6.
Press the "
the clock.
"
" (trip
The clock operates on battery power. Dis-
"
connecting the battery will stop the clock.
Reset the clock after connecting the battery.
EMU36081
Voltmeter
The voltmeter displays the charge of the bat-
tery in volts(V).
EMU26723
Fuel level-alert indicator
If the fuel level decreases to one segment, the
fuel level alert segment will blink.
Do not continue to operate the engine at full
throttle if an alert device has activated. Get
back to the port using trolling engine speed.
NOTICE: Running out of fuel can damage
the engine.
" (set) button again, the
" (mode) button until the
" (set) button again to start
YAMAHA
SPEED
km/h
knot
mph
km
mile
TRIP
TIME
BATT
set
mode
[ECM01771]
ZMU07004
Advertisement
Table of Contents
