Configuring The System For Operation - Omega O-DAQSCAN-2000 Series User Manual

Configuring the System for Operation

DaqLab/2000 Series & DaqScan/2000 Series
Get user manuals: See SafeManuals.com
Step 1 - Install the Software ..... 6-2
Step 2 - Determine the type of Network Connection ...... 6-2
Step 3 - Connect System Components ...... 6-4
Step 4 - Power-up the System ...... 6-5
Step 5 - Configure the Computer's Network Settings ...... 6-6
Step 6 - Configure Device Network Settings using DaqIPConfig ...... 6-9
Step 7 - Configure and Test the System using the Daq Configuration ...... 6-10
Connecting a DaqLab/2000 Series or DaqScan/2000 Series Device to the Ethernet
The DaqLab/2000 Series and DaqScan/2000 Series acquisition devices connect directly to an
Ethernet port on a PC or network hub via a built-in 10/100BaseT Ethernet interface. An
Ethernet patch cable CA-242 (1.5 foot) or CA-242-7 (7 foot) cable is used to make the
connection.
Turn off power to the system devices and externally connected equipment before
connecting cables. Electric shock or damage to equipment can result even under low-
voltage conditions.
Take ESD precautions (packaging, proper handling, grounded wrist strap, etc.)
Reference Note: Adobe PDF versions of user
manuals will automatically install onto your hard drive
as a part of product support. The default location is in
the Programs group, which can be accessed from the
Windows Desktop. You can also access documents
directly from the data acquisition CD via the <View
PDFs> button located on the CD's opening screen.
CAUTION
Minimum System Requirements
PC system with Pentium
Windows Operating System
RAM, as follows:
898195
® Processor
32 Mbytes of RAM for Windows NT
64 Mbytes of RAM for Windows 2000
64 Mbytes of RAM for Windows XP
Configuring the System for Operation
6
6-1