Advertisement
REMOTE STARTER ERROR CODES:
NOTES
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
II After a remote starter failure, the parking lights will fl ash
three [3x] times, then will fl ash [X] number times to
indicate an error code. See table.
REMOTE STARTER SHUTDOWN ERROR CODES:
NOTES
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
II If the engine shuts down after a remote starter sequence:
Press and hold the Trunk button and the Start button at the
same time for 2.5 seconds when using a 1-WAY remote.
OR
Press once [1x] on button "4" when using a 2-WAY remote.
The parking lights will fl ash four [4x] times, then will fl ash
[Y] number times to indicate an error code. See table.
Patent No. US 8,856,780 CA 2759622
Automotive Data Solutions Inc. © 2020
REMOTE STARTER ERROR CODES - 1 OF 1
01
Engine running.
02
Key in ignition at ON position.
03
N/A
04
Trunk is open.
05
Foot brake is ON.
06
Hood is open.
07
N/A
08
Tach failure.
09
N/A
10
System is in Valet Mode.
11
CAN communication failure
12
RS not synchronized. Start vehicle with OEM key for 15 sec before trying a new RS sequence.
01
Engine tach signal is lost.
02
N/A
03
Foot brake is ON.
04
Hood is open.
05
Engine RPM limiter is ON.
06
Glow plug timeout error.
07
Vehicle is moving (VSS).
08
Check engine warning light is ON.
09
Low fuel warning light is ON.
10
N/A
11
CAN communication failure during RS sequence.
FLI-CH(RS)-CH4-[FLRSCH4]-EN
PAGE 15 OF 20
• 20200320
DOC.: #70095
www.flashlogic.com
Advertisement
