Warnings - Park-Daddy PD50AA Installation Manual

• When using this product while sitting in a motor vehicle, check for pedestrians, pets and
objects around you.
• Roll back may occur when a vehicle is in the Park position and the brake is released.
Always let the vehicle settle into position before shutting off the vehicle. It is always
good practice to add a 1 inch safety margin plus a 3 inch roll back margin to insure a safe
clearance from the interior of the garage door to the outer most point of your rear
bumper when installing Infrared Head Units.
• Human error can occur when installing the system. Always check your clearances before
the first use by disengaging the garage door opener and manually shutting the garage
door slowly and visually inspecting the clearance with the vehicle(s) in the parked
position.
• Occasional disruption to the Infrared and Radio signals do to interference from other
sources may cause a deviation in accuracy and range.
• Low battery power may affect the operation of this system.
• If infrared beams are blocked for an excessive period of time or if the Infrared Head
Units are not paired with the batteries installed, battery power will deplete faster than
normal operation.
• Extra weight in back of the vehicle or trunk may change the proper height setting for the
Infrared Head Units.
• Do not look directly into any of the indicator LEDs installed in any part of this product at
a close range for an extended period of time.
• Do not submerge in water.
• Do not expose this product outdoors to raining, icing or snowing conditions.
• Do not leave this product in extreme heat for extended periods of time.
• Low temperatures can affect the life of the batteries.
• Do not use abrasives, harsh cleaners or chemicals when cleaning this product.
• Opening the housings of the Infrared Head Units or RF Radio Receiver may cause
damage to the product and will void the warranty.

WARNINGS