Programming Alternative Channels - Park-Daddy PD50AA Installation Manual

PROGRAMMING ALTERNATIVE CHANNEL
An Alternative Channel can be programmed to the system in the event
another Park-Daddy® system is in operation in the close vicinity and is
causing interference while operating your system. To program an
alternative channel, follow these steps:
1. Make sure the RF Radio Receivers being programmed are within
50 feet of the Infrared Head Units and no vehicles or any other
objects are blocking the Infrared Head Units.
2. Using a thin object such as a toothpick, paper clip, etc., insert that
object into the Channel Programming Hole in Infrared Head Unit
"A" as shown in Figure 1 and hold the switch under the hole down
for 5 seconds until the LED on Infrared Head Unit "A" flashes
Green rapidly.
3. With the RF Radio Receiver powered up, press the (-) and (+)
volume buttons down at the same time for 5 seconds until the
Status Indicator Flashes Red for 5 seconds and then illuminates
Green. Once Green, the RF Radio Receiver is programmed.
4. Repeat the procedure in paragraph #3 for a second and any
additional RF Radio Receives being used with the reprogrammed
system. If other RF Radio Receivers are not reprogrammed, they
will not work with the system.
Once all the RF Radio Receivers are re-programmed, insert the
5.
thin object you used before into the Channel Programming Hole
in Infrared Head Unit "A" and press the switch quickly once to put
Infrared Head Unit back to the normal operating mode. The
Alternative Channel is now programmed.