Installing Rf Radio Receivers - Park-Daddy PD50AA Installation Manual

The Infrared Head Units are now mounted and should be automatically paired.
To confirm that the Infrared Head Units are paired, you will see a short green
flash every 15 seconds from the LEDs on the top of each Infrared Head Unit. If the
LED on Infrared Head Unit "A" has a steady RED, the Infrared Head Units are not
paired properly. Refer to the Trouble Shooting section.
If you do not see a flashing green LED, refer to the Trouble Shooting section of
this User Manual.
If at any time the LED flashes RED every 15 seconds, the battery voltage is low
and the batteries will need to be replaced immediately to ensure safe operation
of the system.
Although very rare, when testing the system and you find the garage door
opener is malfunctioning, swap Infrared Head Unit A with Infrared Head Unit B
and vice versa. This procedure should stop any interference with the garage
door safety sensors. Always check to be sure the garage door opener safety
sensors are functioning properly before use.
INSTALLING THE RF RADIO RECEIVER
1. Installing the RF Radio Receiver is as easy as plugging it into the DC cigarette lighter port.
The status indicator located on the top of the face of the RF Radio Receiver will glow
green or red. (Green if the infrared beams are unobstructed and Red if the infrared
beams is blocked). (See Figure 5)
2. Adjust the RF Radio Receiver to the desired position by rotating the unit and swiveling
the upper portion up or down.
3. Adjust the desired volume of the tone by depressing the (-) or (+) buttons located on the
lower portion of the face of the RF Radio Receiver. (See Figure 5)