Two Way Remote Learning Procedures; Lock/Unlock Mode; Auto-Start Function - CompuSTAR 2WFMRS User Manual

Note:
- Represents pressing the button for 2 seconds.
( ) Represents simultaneously pressing the buttons
( ) – Represents simultaneously pressing the buttons for 2 seconds
T w o W a y R e m o t e L e a r n i n g P r o c e d u r e s
If you replace or add additional remotes, you can program up to three remotes, please perform the following procedure:
Step 1: Activate Valet/Programming mode by manually turning the ignition on and off five times (between Acc and On) with the car key within a 10
second period. The parking lights will flash once with successful completion of this step.
Step 2: Within a 10 second period after cycling the ignition for the 5
confirm that the transmitter has been programmed. Continue program the additional remotes. The parking lights will flash two times when the third
remote has been programmed or programming mode is expired.
L o c k / U n l o c k M o d e
You can lock or unlock the vehicle by pressing Button I for a ½ second or 2 seconds. If you install the optional anti-grind function, this feature
disengages the starter mechanism on your car that prevents you from re-cranking the starter with a manual key, while the engine is running by the
remote start function.
A u t o- S t a r t F u n c t i o n
Press Button II for 2 seconds to auto-start an automatic transmission engine.
Remember that a manual key in the ignition is required to drive the vehicle. In addition, the anti-grind circuit (this maybe an optional feature
provided by your installer) prevents you from re-cranking the starter on a remote-started vehicle. Press Button II for 2 seconds in order to turn off an
auto-started car. For manual transmission vehicles, please use reservation mode.
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset options at the time of installation and then shut off. If your remote-
pager has a problem starting the vehicle, CompuStar will try 2 additional times. If the engine does not start after the third attempt, please call your
authorized CompuStar dealer.
Continuation Mode:
While your vehicle is running with your key in the ignition, press button II for 2 seconds, you are now in the continuation mode. Your engine will
continue running for the preset time even if you take your key from the ignition. With this mode, the engine will continue running without the key
during your quick stop (i.e. at the grocery store).
Diagnosing problems with Auto-Start
If there is a problem in auto-starting your vehicle, you will hear three chirps when you attempt to auto-start the vehicle. Wait for 2 seconds and the
cause for the error will be indicated by the number of times the vehicle parking lights flash.
Error Number (# of times the parking
lights flash)
1
2
3
4
5
6
7
Error Reason
Engine On
Key On
Door Open
Trunk Open
Brake/E-Brake On
Hood Open
Reservation Off (Manual Transmission Only)
© 2001 Firstech, Inc. Page 4
time, press button I for ½ second. The vehicle parking lights will flash once to
th