Table of Contents
Advertisement
Setting the Voice Mail (VM) Tone Detection
Your telephone company sends special signals (Voice mail tones) to
activate the VM indicator. Press
dial tone. If you hear a series of dial tones followed by a continuous dial
tone, this is indication that a new message was recorded. Your phone
comes set to detect these tones (set to "On"). Minutes after you hang up
or after the phone stops ringing, your unit will seize the phone line and
check if a message has been recorded. If a new message was recorded
at your telephone company, "Voice mail" will be displayed on the
handset and the base unit VM indicator will flash.
Set this programming to "Off" when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a
continuous tone, or
—your phone is connected to a business or office telephone system (PBX).
Please refer to below to set this programming to OFF.
If you are not sure which setting is required, consult your local telephone
company or contact Panasonic Customer Call Center.
Make sure the unit is not being used and the handset is lifted off the
base unit.
1
Press
(FUNCTION)
Scroll to "Program" by pressing
2
Press
.
3
á
Scroll to "VM tone detect" by pressing
4
or
.
Ö
Ñ
Press
.
5
á
Select "On" or "Off" by pressing
6
7
Press
(Save key).
á
•A beep sounds.
•To exit the programming mode, press (OFF).
•You can exit the programming mode any time by pressing (OFF).
For assistance, please call: 1-800-211-PANA(7262)
,
.
Ö
Ö
or
(SP-PHONE)
or
.
Ñ
Ringer tone
HProgram
--------------
Save VM acces#
H
VM tone detect
Set line mode
or
.
Ñ
VM tone detect
GF
VM tone detect
to listen to the
:On
H
=Save
:Off
51
Advertisement
Table of Contents
