Chamberlain 8365W Manual page 32

Operation
Remote Control
Your remote control has been programmed at the factory to operate with your
garage door opener.
Older LiftMaster remote controls are NOT compatible, see page 37 for compatible
accessories. Programming can be done through the door control or the learn button the
garage door opener. To program additional accessories refer to the instructions provided
with the accessory or visit LiftMaster.com. If your vehicle is equipped with a Homelink
you may require an external adapter depending on the make, model, and year of your
vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE DOOR CONTROL
1. Press the LEARN button on the door control twice. The Command LED will blink.
2. Remote Control:
Press and release the button on the remote control that you wish to operate your
garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) on the keypad. Then press
the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) and the Command
LED will stop blinking when the code has been programmed. Repeat the steps above for
programming additional remote controls or keyless entry devices. If programming is
unsuccessful, program the remote using the learn button.
1
LEARN button
2
Command LED
OR
? ? ? ?
PIN
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL USING THE LEARN
BUTTON
1. Press and release the LEARN Button on the garage door opener.
2. Press and hold the button on the remote control that you wish to use. Release
the button when the garage door opener lights blink or two clicks are heard.
1
®
,
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARN button on garage door opener until the learn LED goes
out (approximately 6 seconds). All remote control and keyless entry codes are
now erased. Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
1. Press and hold the LEARN button on garage door opener until the learn LED goes
out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the learn LED goes out.
All codes are now erased. Reprogram any accessory you wish to use.
ERASE THE Wi-Fi NETWORK FROM THE GARAGE DOOR OPENER
1. Press and hold the black adjustment button on the garage door opener until 3
beeps are heard (Approximately 6 seconds).
®
ERASE A MyQ ACCOUNT
Go to myLiftMaster.com to delete your MyQ account.
32
2
LEARN
Button
LEARN LED
®
enabled accessories)
LEARN Button
Black Adjustment Button