Flex FX1331 Operator's Manual page 14

WARNING
product damage due to a short circuit, never
immerse your charger or battery pack in
fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This impact driver must be used only with the battery packs and chargers listed below:
2.5Ah 3.5Ah
FX0111 FX0321 FX0121 FX0331
NOTICE: Please refer to the battery pack and charger manuals for detailed operating information.
TIGHTEN AND LOOSEN SCREWS, NUTS
AND BOLTS (FIG. 10 AND 11)
Select the " " mode as necessary, based on
your application. For more details see related
section: Mode Selection. For mode 1 or 2:
variable-speed control must be used with
caution for driving nuts and bolts using socket-
set attachments. The best technique is to start
slowly, increase speed as the nut or bolt runs
down, and then set the nut or bolt snugly by
slowing the tool to a stop. If this procedure is
not followed, the tool will have a tendency to
torque or twist in your hand when the nut or bolt
seats.
It is advisable to perform a trial run on a scrap
material to determine the best mode selection.
a. Install a suitable bit.
b. Apply just enough pressure to keep the bit
engaged on the screw or nut.
c. For mode 1 or 2, apply minimal pressure
to the variable-speed trigger switch initially.
Increase the speed only when full control can
be maintained.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
Battery Pack
5.0Ah 6Ah
WARNING
accessories not recommended for use with
this charger. Any such alteration or
modification is misuse and could result in a
hazardous condition leading to possibly serious
personal injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
8.0Ah 10Ah 12Ah
FX0221 FX0341 FX0231
Fig. 10
-14-
Do not attempt to modify
the charger or create
To prevent accidental
starting that could cause
Charger
FLEX FLEX
FX0411 FX0421
FLEX
FX0431