Flex FX1331 Operator's Manual page 10

REMOVABLE BIT CLIP (FIG. 4)
Your tool is also equipped with a removable bit
clip that can be positioned on the side of the
tool for storing bits.
Install the bit clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the hole of the bit clip with the threaded
hole on the base of the tool.
NOTICE: Ensure that the protruding part on the
bit clip is kept flush against the step on the base
of the tool to keep it steady.
c. Insert the screw and securely tighten the
screw with a screwdriver (not included).
Remove the bit clip from the tool:
a. Remove the battery pack from the tool.
b. Use a screwdriver to loosen the screw that
attaches the bit clip to the impact driver.
c. Remove the screw and the bit clip.
INSTALL AND REMOVE BITS (FIG. 5)
Your tool is equipped with a quick-change chuck,
making the bit installation and removal very easy.
Lock the variable-speed trigger switch OFF by
placing the direction-of-rotation selector in the
center position.
To install the bit:
Pull the locking sleeve forward (away from the
tool), insert the bit as far as it will go into the
chuck, and release the locking sleeve to lock
the bit.
To remove the bit:
Pull the locking sleeve forward (away from the
tool). Pull the bit from the chuck and release the
sleeve.
NOTICE: Use only bits with power grooves;
other bits can be used with a universal bit
holder that has power groove (not included). Do
not use a bit that has a damaged shank.
WARNING
from the tool, or first allow the bit to cool
down. The bit may be hot after prolonged
use.
Use protective gloves
when removing the bit
Fig. 4
Removable Bit Clip
Fig. 5
Locking Sleeve
-10-
Step
Protuding
Part