Table of content 1.Open-Package guidelines............... 1.1Package....................1 2.Safety instructions..................1 3.Operating determination.................2 4.Rigging the fixture...................3 4.1 Mounting.....................3 4.2Installing the Clamps................3 4.3 Power supply connection and cut off...........4 4.4 Power Connection................4 4.5 DMX-512 connection/connection between fixtures......4 Description of the device............
Page 4
Congratulations on choosing our products! Please carefully read this instruction manual in its entirety and keep it well for using reference. This manual contained about the installation and the relative using information of this products. Plese refere this manual's relative instruction when using this equipment.
1.Open-Package guidelines This equipment is made of new style,high intensity plastic.It fully shows the modem times light charac teris- tic with teristic with beauty struture. And it is made accord to CE standard. Fully agree with the internation standard of DMX 512 agreement.
Minimum distance of illuminated objects 0.8m The projector needs to be positioned so that the objects hit by the beam of light are at least 0.80 metres from the lens of the projector. Maximum ambient temperature ° C t 45 Do not operate the fixture if the ambient temperatuer(Ta) exceeds 45°...
The minimum distance between light output and the illuminated surface must be more than 0.2 meters. Make sure that the area below the installation place is blocked when rigging,derigging or servicing the fixture. Always fix the fixture with an appropriate safety rope, Fix the safety rope at the correct holes only. Operate the fixture after having checked that the housing is firmly closed and all screws are tightly fastend.
The projector should be installed outside areas where persons m ay walk by or be seated. Important!Overhead rigging requires extensive expering CE,including (but not limited to) calculating working load limits, installation material being used, and periodic safety inspection of all installation ma- terial and the projector.
Page 9
Caution At the last fixture,the DMX-cable has to be terminated with a terminatou. solder a 120 resistor between signal(-) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture. DMX output DMX iutput 3-pin XLR socket 3-pin XLR socket 1:Ground...
6.Dimension 单位:(m m) 7.Display control 7.1 Navigation in the Menu Using the buttons, and this can be simply and easily set the address code and function code. If you view or modify the lighting feature set, then press ENTER button, the display will enter the menu interface.
8.DMX protocol Mode1 Name Function DMX Value Closed Dimming Dimming 0%-100% 6-240 241-255 OPEN No Effect 0-10 Pulse up 1 (slow) 11-20 Pulse up 2 21-30 Pulse up 3 31-40 Pulse up 4 41-50 Pulse up 5 51-60 Pulse up 6 61-70 Pulse up 7 (fast) 71-80...
Mode1 Name Function DMX Value Color 7 White 134-183 Proportional clockwise rotation SLOW→FAST Color Wheel 184-194 White Proportional counterclockwise rotation FAST→SLOW 195-244 White 245-255 Stop Water Wheel Counterclockwise rotation FAST→SLOW 1-127 Clockwise rotation SLOW→FAST 128-255 Gobos Indexing Gobo 1 0-16 Gobo 2 17-33 Gobo 3...