Table of Contents
Advertisement
Caution
At the last fixture,the DMX-cable has to be terminated with a terminatou. solder a 120 resistor between
signal(-) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
DMX output
3-pin XLR socket
DMX Terminator Diagram
-For installations where the DMX cable has to run a long distance or
is In an electrically noisy environment it is recommended to use a
DMX terminator. This help in preventing corruption of the signal by
electrical noise. The DMX terminato r is simply an XLR plug witha
Ω
120
resistor connected between pins 2 and pins3, which is then
plugged into a the output XLR socket of the last ifxture in the chain.
DMX iutput
3-pin XLR socket
2
1
2
2
3
3
3
- 5 -
1:Ground
2:Signal(-)
1
1
3:Signal(+)
2
1
3
120Ω
PIN2
PIN3
Advertisement
Table of Contents
