Connecting The Camera; When Mounting Directly - Sony VAIO PCGA-UCVC11 Operating Instructions Manual

Connecting the Camera

When mounting directly

GB
14
Downloaded from:
This section describes how to connect the camera to your computer.
Notes
• When using the camera for the first time, make sure that you install the driver and the
software before connecting the camera to your computer. For installation details, see
"Setting Up the Camera" (page 7).
• Do not connect or disconnect the camera's USB cable while your Windows operating
system is starting or shutting down. Doing so may cause the camera or your computer
to malfunction.
• Do not disconnect and then quickly reconnect the camera's USB cable. Doing so may
result in unstable operation of your computer.
• This camera is designed to constantly secure a fixed amount of USB bandwidth for data
transfer to display high-quality images. Therefore, if you use a USB hub to connect
multiple USB devices simultaneously, the amount of bandwidth available for data
transfer may be insufficient to support proper operation.
To mount to a computer that use a raised type display panel, such as those
found on notebook computer or LCD unitized desktop model, the camera
can be mounted directly by fitting the camera arm onto the display panel, as
shown below.
1
Mount the camera onto the display panel.
Holding the arm plate, pull out the rear arm as shown in the illustration
below, and hang the camera on top of the display panel.
https://www.usersmanualguide.com/
Arm
Display Panel
Arm plate