Table of Contents
Advertisement
Available languages
Available languages
Spillovers on the
1. Switch the power to the
touch controls
cooktop off.
2. Soak up the spill
3. Wipe the touch control area
with a clean damp sponge or
cloth.
4. Wipe the area completely
dry with a paper towel.
5. Switch the power to the
cooktop back on.
Hints and Tips
Problem
Possible causes
The cooktop cannot
No power.
Be turned on.
The touch controls are
The controls are locked.
unresponsive.
The touch controls are
There may be a slight film of
difficult to operate.
water over the controls or you
may be using the tip of your
finger when touching the
controls.
The glass is being
Rough-edged cookware.
scratched.
Unsuitable, abrasive scourer or
cleaning products being used.
Some pans make
This may be caused by the
crackling or clicking
construction of your cookware
noises.
(layers of different metals
vibrating differently).
• The cooktop may beep and turn
itself off, and the touch controls
may not function while there is
liquid on them. Make sure you
wipe the touch control area dry
before turning the cooktop back
on.
What to do
Make sure the cooktop is connected
to the power supply and that it is
switched on.
Check whether there is a power
outage in your home or area. If
you've checked everything and the
problem persists, call a qualified
technician.
Unlock the controls. See section
'Using your ceramic cooktop' for
instructions.
Make sure the touch control area is
dry and use the ball of your finger
when touching the controls.
Use cookware with flat and smooth
bases. See 'Choosing the right
cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
EN-15
Technical Specification
Cooking Hob
Cooking Zones
Supply Voltage
Installed Electric Power
Product Size L×W×H(mm)
Built-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually strive to
improve our products we may change specifications and designs without prior
notice.
Installation
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by
the heat radiation from the hotplate. As shown below:
A(mm)
B(mm)
C(mm)
268
500
＋4
＋4
50mini
-0
-0
CHEDD30CTT/1
2 Zones
220-240V~, 50-60Hz
2928-3484W
288X520X52
268X
500
D(mm)
E(mm)
F(mm)
50 mini
50 mini
50 mini
EN-16
Advertisement
Table of Contents
