Backup: Step 1 - ZyXEL Communications NAS320 User Manual

Table 79 Protect > Backup
LABEL
Execute Job Now
Restore Archive
Abort Job
Activate Job
Inactivate Job
Status
Job Name
Job Description
Backup Info
Scheduler Info

11.15.1 Backup: Step 1

Use this screen to specify the job information and back up type.
Click Add Job in the Protect > Backup screen to open the following:
Figure 139 Protect > Backup: Step 1
Media Server User's Guide
DESCRIPTION
Select a backup job in the list and click this to run the backup job immediately.
Select a backup job in the list and click this to restore the file(s) included in that backup
job to the NSA.
This applies to Archive backups only. Refer to
screens.
Select a backup job in the list and click this to stop the process if the backup job is
currently active.
Enable the selected backup job.
Disable the selected backup job.
This shows the current state of the backup job.
• Waiting means the backup job is not active but is scheduled to run at some time.
• Running indicates that the NSA is currently doing the backup job. When the backup
job is running, you can also see a progress bar.
This identifies the backup job.
This is a short description of the backup job.
This lists down the backup job details: type, source and target. Refer to
on page 265 and Section 11.15.2 on page
This shows the backup schedule, including the frequency, the time it was last run in
(and whether or not it succeeded), and when it is scheduled to run again. The times use
yyyy-mm-dd hh:mm:ss format.
Refer to Section 11.15.4 on page
Section 11.15.8 on page 274
267.
271.
Chapter 11 Packages
to see the
Section 11.15.1
265