JBL 4329P Owner's Manual page 2

3. Back Panel Overview
Primary
A
B
C
D
E
4329P
F
POWERED STUDIO MONITOR 有源演播室监听音箱
G
XLR / ¼" Balanced Input Sensitivity Selection – Select
A either; -10dB (High sensitivity mode) or +4dB (Low
sensitivity / protects input front-end from overload)
B Left & Right XLR / ¼" Balanced Inputs
Ethernet: Connect to available port on router for wired
C
streaming
USB-A + Service button: For service / firmware updates
D
ONLY (Not for Audio or USB Charging)
Reset: Factory Reset – press and hold until lights on
E
the front panel begin to flash
Primary Speaker Sync Button: Use to connect
F
wirelessly to Secondary speaker
Primary Speaker IEC Power connection – a universal
G power supply is incorporated allowing these to be used
domestically and internationally.
H 3.5mm analog stereo input
I Toslink / Optical digital input
J USB-B Digital Direct PCM input
4329P OM | Part No: 950-0628-001 | Rev 1.0 20221201
© 2023 HARMAN International Industries. Incorporated All rights reserved.
H
I
J
P
K
Q
L
M
N
Manufacturer 制造商 Harman International Industries, Incorporated
8500 Balboa Blvd, Northridge CA 91329 USA
Designed and engineering in USA
Made in China 中国制造
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not ause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Contains Transmitter Module FCC ID: UA9601
Contains Transmitter Module IC: 9129A-601
responsible for compliance could void the user's authority to operate the equipment.
R
O
Bass Contour switch:
K For boundary compensation adjustment – 0dB or -3dB
selectable
Sub-Woofer Output: When utilized, an 80Hz high-pass
L
filter is activated for system
Primary Speaker Digital Link: To create wired connection
M between Primary and Secondary speaker via CAT5e or
higher cable (Max length 20' / 6m)
L/R Assign Selector: Select L or R depending on the
N
intended listening position for the Primary speaker
O Primary Speaker Main Power switch: I = On / O = Off
Secondary Speaker Sync Button: Use to connect
P
wirelessly to Primary speaker
Secondary Speaker Digital Link: To create wired
Q connection between Primary and Secondary speaker via
CAT5e or higher cable (Max length 6m)
Secondary Speaker IEC Power connection - a universal
R power supply is incorporated allowing these to be used
domestically and internationally.
S Secondary Speaker Main Power switch: I = On / O = Off
Secondary
4329P
POWERED STUDIO MONITOR 有源演播室监听音箱
EN
S
Pg 2 of 11