Table of Contents
Advertisement
LED Status
Solid Green (Connected):
•
The gateway is connected to all the MQTT devices that are configured and enabled
Flashing Green (Not Connected):
•
No MQTT devices are configured / enabled. Go to the MQTT Client Device Configuration to
configure a device
Flashing Red (Not Connected):
•
One or more of the MQTT brokers configured are missing (nodes missing)
•
One or more of the MQTT brokers configured do not have topics configured
•
The Dependency Protocol has faulted
Flashing Red (Communication not attempted yet):
•
No topics are configured and data needed for writes isn't valid yet
Solid Red (Invalid Configuration):
•
No devices are enabled
•
One or more of the MQTT devices have a conflicted IP address
Off:
•
No Power
•
No Ethernet cable connected
Variables: These are the values for all servers, or the specific server selected.
Network Bitmap Status (Displayed in Hex):
•
Each bit corresponds to a MQTT device. If the bit is set, the MQTT device is connected,
otherwise the bit is 0.
•
Bit 0 corresponds to MQTT device 1 and Bit 4 is for MQTT device 5 and so on.
Published Messages to MQTT:
•
Number of Write Topics which have been sent to the MQTT broker
Published Messages from MQTT:
•
Number of Read Topics which have been sent from the MQTT broker to the gateway
Subscribed Messages Actual:
•
Number of Successful Subscribed Topics
•
This should equal the Subscribed Messages Expected
Subscribed Messages Expected:
•
Number of Subscribed Topics that the gateway should have open
Real Time Automation, Inc.
73
1-800-249-1612
Advertisement
Table of Contents
