Trane Technologies 4TWL6018A1000A Installer's Manual
  1. Manuals
  2. Brands
  3. Trane Technologies Manuals
  4. Air Conditioner
  5. 4TWL6018A1000A
  6. Installer's manual

Trane Technologies 4TWL6018A1000A Installer's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Installer's Guide
Side Discharge HP Models
For coastal applications where units are installed within one (1) mile of salt water, epoxy coated models are recommended. These models
have an 8 week lead time after order.
4TWL6018A1000A
4TWL6024A1000A
4TWL6030A1000A
4TWL6036A1000A
4TWL6042A1000A
4TWL6048A1000A
4TWL6060A1000A
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
May 2020
E E p p o o x x y y C C o o a a t t e e d d M M o o d d e e l l
4TWL6018A1COTA
4TWL6024A1COTA
4TWL6030A1COTA
4TWL6036A1COTA
4TWL6042A1COTA
4TWL6048A1COTA
4TWL6060A1COTA
S S A A F F E E T T Y Y W W A A R R N N I I N N G G
1 1 8 8 - - B B C C 9 9 9 9 D D 1 1 - - 1 1 E E - - E E N N
N N o o t t e e : : "Graphics in this document are for representation
only. Actual model may differ in appearance."

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4TWL6018A1000A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Trane Technologies 4TWL6018A1000A

Summary of Contents for Trane Technologies 4TWL6018A1000A

  • Page 1 8 week lead time after order. E E p p o o x x y y C C o o a a t t e e d d M M o o d d e e l l 4TWL6018A1000A 4TWL6018A1COTA...
  • Page 2 SAFETY SECTION I I m m p p o o r r t t a a n n t t — This document contains service C C A A U U T T I I O O N N information. This is customer property and is to remain G G R R O O U U N N D D I I N N G G R R E E Q Q U U I I R R E E D D ! ! with this unit.

  • Page 3: Table Of Contents

    Table of Contents Unit Location Considerations ....4 System Start Up ......18 Unit Location Considerations .

  • Page 4: Unit Location Considerations

    Unit Location Considerations Table 1. Unit Dimensions (in inches) and Weight H x D x W (in) Weight * (lb) Models 36.75 x 14 1/2 x 40 4TWL6018A 26.75 40.0 30.75 14.5 16.5 17.5 36.75 x 14 1/2 x 40 4TWL6024A 26.75 40.0...
  • Page 5 U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Table 2.

  • Page 6: Unit Location Considerations

    U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Unit Location Considerations Table 3.
  • Page 7 U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Table 3.

  • Page 8: Unit Preparation

    U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Unit Preparation Check for damage and report promptly to the carrier any damage found to the unit.

  • Page 9: Refrigerant Line Considerations

    U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s I I m m p p o o r r t t a a n n t t : : H H e e a a t t P P u u m m p p m m o o d d e e l l s s s s h h o o u u l l d d n n e e v v e e r r b b e e s s t t a a c c k k e e d d ! ! Refrigerant Line Considerations...
  • Page 10 U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Table 10.
  • Page 11 U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Table 13.

  • Page 12: Refrigerant Line Brazing

    U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Refrigerant Line Brazing Table 16.
  • Page 13 U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Table 16.

  • Page 14: Refrigerant Line Leak Check

    U U n n i i t t L L o o c c a a t t i i o o n n C C o o n n s s i i d d e e r r a a t t i i o o n n s s Refrigerant Line Leak Check Table 17.

  • Page 15: Service Valves

    Service Valves Table 18. Open the Gas Service Valve 1/4 Turn Only Important: Leak check and evacuation must be completed before opening the service valves. Counterclockwise Note: Do not vent refrigerant gases into the atmosphere. for Full Open Position Remove valve stem cap. Using a wrench, turn valve stem 1/4 turn counterclockwise to the fully open position.

  • Page 16: Communicating

    Electrical — Low Voltage Non Communicating Table 20. Low Voltage Maximum Wire Length 24 VOLTS The table defines the maximum total length of low voltage wiring WIRE SIZE MAX. WIRE LENGTH from the outdoor unit, to the indoor unit, and to the thermostat. Note: The use of color coded low voltage wire is recommended to 18 AWG 150 Ft...

  • Page 17: Electrical - High Voltage

    E E l l e e c c t t r r i i c c a a l l — — L L o o w w V V o o l l t t a a g g e e N N o o n n C C o o m m m m u u n n i i c c a a t t i i n n g g Electrical —...

  • Page 18: System Start Up

    E E l l e e c c t t r r i i c c a a l l — — L L o o w w V V o o l l t t a a g g e e N N o o n n C C o o m m m m u u n n i i c c a a t t i i n n g g System Start Up Set the system thermostat to OFF.

  • Page 19: Subcooling Charging In Cooling Between 55° F And 120° Od

    Subcooling Charging in Cooling between 55° F and 120° OD Ambient Trane has always recommended installing Trane 4. Measure Liquid Line Temperature and Refrigerant approved matched indoor and outdoor systems. Pressure at service valves. 5. Determine total refrigerant line length, and height The benefits of installing approved indoor and outdoor (lift) if indoor section is above the condenser.

  • Page 20: System Charge Adjustment

    System Charge Adjustment Table 24. Temperature Measurements (Systems can be rated with TXV, EEV or Piston. Ensure charging method is correct). Check the outdoor temperatures. 120° F Subcooling using “Charging Mode-Cooling” is the only recommended method of charging between 55 ° F and 120° F ambient outdoor temperature.

  • Page 21: Refrigerant Charging Chart

    Refrigerant Charging Chart R-410A REFRIGERANT CHARGING CHART DESIGN SUBCOOLING (°F) LIQUID TEMP (°F) LIQUID GAGE PRESSURE (PSI) 18-BC99D1-1E-EN...

  • Page 22: Subcool Charging Charts

    Subcool Charging Charts Figure 1. 1.5 Ton Models Figure 5. 3.5 Ton Models SUBCOOL CHARGING CHART CORRECTIONS TABLE (FOR LINE LENGTH AND RISE) SUBCOOL CHARGING CHART CORRECTIONS TABLE (FOR LINE LENGTH AND RISE) Add 4° Add 1° 4° Add 1° Add 1°...

  • Page 23: Charging The Unit

    Charging the Unit Table 26. Stabilize the system Wait 20 minutes for the system condition to stabilize between adjustments. Note: When the Liquid Line Temperature and Gage Pressure 20 MIN. approximately match the chart, the system is properly charged. Remove gauges. Replace service port caps to prevent leaks.
  • Page 24 C C h h a a r r g g i i n n g g t t h h e e U U n n i i t t Table 29. Proper Gage Pressure Adjust refrigerant level to attain proper gage pressure. Add refrigerant if the Liquid Gage Pressure is lower than the chart value.

  • Page 25: Checkout Procedures

    Checkout Procedures The final phase of the installation is the system Checkout Procedures. The following list represents the most common items covered in a Checkout Procedure. Confirm all requirements in this document have been met. ☐ All wiring connections are tight and properly secured. ☐...

  • Page 26: Troubleshooting

    Troubleshooting Compressor fails to start Contactor check Is contactor engergized? Go To: Compressor won’t run (contacts closed) Wait 3 minutes and check contactor Check for 24 volts AC coil again across contactor coil Is voltage If applicable, is TDR present at input voltage Replace contactor contactor coil?

  • Page 27: Troubleshooting

    T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g Troubleshooting Does a resistance check show an open circuit between R and S? 18-BC99D1-1E-EN...
  • Page 28 Trane - by Trane Technologies (NYSE: TT), a global innovator - creates comfortable, energy efficient indoor environments for commercial and residential applications. For more information, please visit trane. com or tranetechnologies.com. The AHRI Certified mark indicates Trane U.S. Inc. participation in the AHRI Certification program. For verification of individual certified products, go to ahridirectory.

This manual is also suitable for:

4twl6024a1000a4twl6030a1000a4twl6036a1000a4twl6042a1000a4twl6048a1000a4twl6060a1000a ... Show all

Table of Contents