Table of Contents
Advertisement
Problem
The washing results
are not satisfactory.
Too much foam in
the drum during the
washing cycle.
The detergent/fabric
softener level does
not decrease in the
AutoDose tanks after
washing.
After the washing cy‐
cle, there are some
detergent residues in
the dispenser drawer.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre is on the rating plate.
16. CONSUMPTION VALUES
16.1 Introduction
See the web link www.theenergylabel.eu for
detailed information about Energy Label.
Possible solution
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• When using AutoDose tanks, make sure that they are not
empty.
• When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph
in "The AutoDose Technology" chapter.
• Make sure that you have cleaned the AutoDose tanks be‐
fore using different brand and type of detergent, fabric
softener or other additives.
• Reduce the quantity of detergent.
• When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph
in "The AutoDose Technology" chapter.
• This is normal: tanks are quite large and detergent con‐
sumption may be not so evident.
• Make sure that the flap is in the correct position (UP for
powder detergent - DOWN for liquid detergent).
• Make sure you have used the detergent dispenser accord‐
ing the indications given in this user manual.
ENGLISH
51
Advertisement
Table of Contents
